Manual strong suction gun

Packaging: Blister card

Material: ABS with sponge cover

Weight: 78g with packaging, 54g without packaging

Temperature adjustment range: 300 (℃)

Suction: 35 (cm-Hg)

Sealing gas ring: Double ring

Instructions:

1. First, press down the piston of the solder remover until it locks.

2. Heat the solder with a soldering iron until the solder melts.

3. When removing the soldering iron, quickly attach the solder suction nozzle to the solder and press the solder suction button.

4. If the suction is not clean at once, the operation can be repeated many times.

Tips for using the solder sucker:

1. Ensure that the piston of the solder remover is well sealed. Before powering on, block the hole of the solder suction head with your fingers and press the button. If the piston is not easy to pop out, it means the seal is good.

2. The hole diameter of the solder suction head comes in different sizes, and it is necessary to choose the correct specification for use.

3. When the solder suction head is worn out, it should be replaced with a new one in time.

4. Before touching the solder joints, dip a little resin each time to improve the fluidity of the solder.

5. The time for the head to contact the solder joint is a little longer. When the solder melts, take the solder joint as the center, draw a clockwise circle with your hand outwards, and then press the button of the solder remover.