Color: White3D football lamp with crack sticker, making it look like the object has broken through the wall. How to install your 3D crack sticker: 1. Unfold the sticker and flatten creases. 2. Place the sticker in the desired location, place tape (painter's tape or similar) at the edge of the top of the sticker and mark arrows on tape and sticker for placement reference. 3. Carefully remove the backing of the sticker. 4. Align the arrows and carefully attach the top (top 1-2 inches) of the sticker to the wall, making sure to keep the bottom away from the wall. 5. Use a credit card or a blunt flat surface to slowly attach the sticker, pressing against the paper backing and removing any air bubbles that may occur, remember to keep the lower part of the sticker off the wall as you work your way down, out and towards the edges until the end. 6. Very slowly peel the paper away from the wall, making sure the (fine edges) stick to the wall. If any of the sticker comes off with the paper, reapply it to the wall and press firmly with a credit card until the sticker adheres to the wall. 7. Drill a hole in the spaces marked with X and insert the wall plug provided. Insert the screws provided about halfway and place the lamp on the screws. 8. Enjoy! How to remove your 3D crack sticker without damaging your wall. Warning: Removal of the sticker should only be done by an adult. 1. Remove the screws from the wall before removing the crack sticker. 2. Use a regular hairdryer and set the heat to the highest setting. 3. Apply heat to the sticker evenly, holding the dryer 1-2 inches from the wall. 4. Make sure to heat the entire surface before attempting to remove the sticker. 5. Once you have heated the entire sticker, begin to remove the sticker from the top and slowly peel it off the wall in a downward motion. 6. Place the dryer above the sticker as you peel it off to release the adhesive. 7. For best results, please do not rush this process. Take your time and remove the stic \",