Metal Tool for Car Dent Repair, Dent Puller, Car Body Dents, Suction Cup, T-Puller + 18 Tabs. Features: It is made of metal for high strength and durability. A necessary component for dent repair, direct replacement for the broken one. Easy installation, thread size is M10 for better application. Specification: Material: Metal Color: As shown Type: M10 Size: As shown What's included: T-puller + 18 tabs How to use these paintless dent repair kits: 1. Clean the dent with a clean damp cloth 2. Insert the glue stick into the glue gun, pull the trigger to let the glue stick into the glue gun, connect the power source and preheat for 5 minutes. 3. Use an appropriate pulling tab. A large dent requires a large pulling tab. (Note: the larger the pulling tab, the greater the pulling force) 4. Pull the trigger and apply the pulling tab with extruded glue (the 4 L?? of the tab must be applied with hot melt glue) 5. Quickly place the pulling tab in the center of the dent with hot melt glue, press lightly until the glue hardens and sticks (let the glue cool for about 8 minutes. The cooling time should be less than 10 minutes and be a little shorter in winter) 6. Align the T-shaped repairer and press the tension joint with hot melt glue. Pull back on the slide bar to lift the dent. 7. Check this with a line board. If the dent is still there, tap it lightly with a hammer or a leveling tool. 8. Clean the repaired area with a clean, damp cloth