NOTE:
Some vehicles need an additional lamp adapter (not included) for the LED bulbs to replace the halogen bulbs.
For some vehicles, installation of a decoder or a load resistor may be required to avoid error messages, hyper flashing turn signals, or rapid flashing.
This listing does not include a lamp adapter, some cars need an additional lamp adapter for the LED bulbs to replace the halogen bulbs (normally H7 and H1 need a special adapter).
This kit is for vehicles with factory-installed halogen systems, it does not work with vehicles with factory-installed HID. Please confirm that the item matches your car before purchasing.

Technical specification:
Power: 100W/pair, 50W/bulb
Plug type: H7 + H11 (High Beam & Low Beam)
Luminous flux: 11000LM/set (5500LM/bulb)
Operating voltage: DC 12V (fits 12V vehicles)
Color temperature: 6000K White
IP68 rated water and dust seal, over 50000 hours lifespan
Beam angle: 360 degrees
Material: Aviation aluminum 6063 profile
Operating temperature: -40 ~ +80 degrees Celsius
Application: H7 high beam, H7 low beam, H7 H7L fog light, reverse light, turn signal, position light, compartment light, trunk light, door light, instrument light and so on; as long as the factory bulbs are H7 halogen bulbs, our bulbs will fit and work, plug and play.

Advantage:
*Latest 3570 CSP chip (USA) light source, 2 light surfaces no blind zone
*Engineered beam pattern design casts more light on the road evenly at an appropriate angle without foggy light
*White light reflects road markings/signs better to show a clearer road situation during night driving
*270 degree low beam angle with cut-off line, will not dazzle oncoming traffic
*Built-in constant current CPU, instant full brightness without start-up relay

Installation warning:
1. As a safety precaution, make sure the car has had time to cool down properly before starting the installation process.
2. Put the vehicle in park or make sure it is securely in gear.
3. Make sure the ignition is off and the keys are removed.
4. Be careful to avoid burns, especially when turning on or off the vehicle's lighting.
5. Be careful to avoid crushing or cutting the bulbs. Also make sure not to touch the bulbs with your fingers, as this will cause stains.
6. Carefully examine the connection of the contact points, ports and wires as incorrect connections can cause lighting problems.
7. Make sure the end of the bulb does not come into contact with the inner light shield of the headlight when adjusting the bulb.
8. Install the dust cover for the car headlight to ensure the normal operation of the bulb.

Package included:
4 pcs LED bulbs, H7 + H11 (High Beam & Low Beam)
100% brand new and high quality. Plug and play

Fewer components damaged, the probability of repair is very low, compared to HID ballast repair lower than 80%.

No dark spots or shadowy areas, perfect performance in poor visibility conditions due to rain, fog, dust or snow.

Instant start without strong current impact, effectively protects the car's battery, improves battery life by more than 30%.

Fast cooling, the most advanced design appearance, thermal structure ingenious and reasonable. Less warranty, power driver with wide voltage constant current mode, the car can respond to a variety of voltage instabilities, the effective protection of normal use Led efficient and simple structure.