Dear friends:Kit of LED strips for decorationThe RGB light bar kit includes all accessories. Equipped with 20-meter LED strips (consisting of 4 5-meter LED strips), infrared remote control, infrared controller, 4-port parallel cable and power adapter. The power plug can be directly connected to the power outlet at home, plug and play design, installation is very simple, you can install led lights in a few minutes.The RGB light strip is designed with self-adhesive tape and the back is covered with high-strength self-adhesive glue. Peel off the protective film from the back of the RGB light strip, and then directly stick it on a clean surface (wall, ceiling, furniture, glass, plastic, metal, etc.).This RGB light strip is very flexible and durable, it can be bent at will without damaging it. It can also be cut. After measuring the required length, use scissors to cut off the excess along the cut mark.This LED strip is very special. Unlike other light strips, it can display multiple colors at the same time. It is made up of three different colors of LED lamp beads, namely red, green and blue. 60 LED lamp beads per meter. Every three colors is a cycle, You can mix two different colors of LED lamp beads to get light other colors (For example, when the red LED lamp beads and the blue LED lamp beads are displayed at the same time, you can get violet light) .There are also 6 lighting modes to choose from, and the brightness of the LED light bar can be adjusted.------Remote control instructions:1 . Adjust the brightness, darken or darkentwo . Pause / start button, on / off button3. Color buttons:A: show the red lightG: show green lightB: show blue lightW: red lights, green lights and blue lights are on at the same timeOther color buttons: each color button is obtained by mixing two-color LED lights between red, green and blue (For example, press the purple button, the LED light strips will turn on the red lights and blue lights at the same time. The controller obtains violet light by adjusting the intensity ratio of the red lights and the blue lights), all colors are obtained by this method.4. The arrow buttons adjust the brightness of the red light, green light and blue light respectively. You can combine different light colors by manually adjusting the brightness of the red lights, green lights and blue lights, 6 combinations can be saved.5.Six dynamic lighting modes (3 combinations of jump change, 7 combinations of jump change, 3 combinations fade change, 7 combinations fade change, flash on and off, automatic change)6.Adjust the speed of dynamic lighting mode, faster or slower------The working voltage of the LED light bar is 12V, the working temperature is very low, and it will not harm the human body. Children can also touch it safely.LED strip light kit list:4 x 5 meter LED strip (20 meters in total)1 x infrared remote control (battery included)1 x infrared controller1 x power adapter1 x parallel cable with 4 portsThe 20 meter LED strip is made up of four 5 meter LED strips. They are connected in parallel and must be installed according to the correct method in the picture.Note:1. (Important) Do not roll up the LED light bar when in use, because the rolled up LED strip will cause heat to accumulate and cannot dissipate it. To prevent the whole light bar from overheating, the LED light bar rolled up can not work for a long time and can only be tested in a short time, the expanded LED light bar can be installed and used normally.2. (Important) Make sure it is installed correctly according to the method in the product manual. The wrong installation method may lead to abnormal lighting. If you have any questions during the installation process, please leave us a message.