Specification:
Material: Polyurethane, Stainless Steel
Color: Gold Tone, Black, Clear
Bridge Hose Inner Diameter: 9 mm/0.35 inch
Bridge Hose Length: 64 cm/25.1 inch
Bridge Hose Outer Diameter: 10 mm/0.39 inch
Fill Hose Thread Size: 1/4 NPT
Fill Hose Hole Diameter: 8 mm/0.31 inch
Fill Hose Length: 66.7 cm/26.2 inch
Fill Hose with Screw Cap Diameter: 26 mm/1.02 inch
Fill Hose with Screw Cap Outer Diameter: 12 mm/0.47 inch

Fitment:
Fits Seastar inboard and outboard hydraulic steering systems. Used to refill the steering fluid in your boat.

Basic Instructions:
1. Attach the bottle to the steering reservoir (do not puncture the bottle) (do not let the bottle run empty).
2. Connect the bridge hose to the fittings on the steering cylinder and loosen the fittings.
3. Use the steering to pump fluid through the system by turning the wheel in one direction. Air bubbles will be pushed to the reservoir at the steering.
4. Manually swing the outboard motor through its full range of motion to release trapped air.
5. Note: Pointing the fittings upwards while pumping fluid with the steering will allow air to escape from the cylinder.
6. Repeat steps 3-4 as many times as needed until no air is visible in the bridge hose.
7. Tighten the fittings before removing the bridge hose.

Package Content:
1 x Bridge Hose
1 x Fill Hose with Screw Cap