Note: The throttle is marked as 48V, and the default is also 48V. However, 24V, 36V, 48V, 60V, and 72V can all be used, and the buyer must set the voltage themselves.
This is a throttle that can display speed and mileage,
suitable for most brushless controllers and has a wide range of applications.
The voltage is 24V 36V 48V 60V 72V Universal, which can be set according to the buyer's needs.
(First, press and hold the M button, then turn the key to start the machine,
then long press and hold the M button until the voltage parameter flashes,
then short press and hold the M button to switch the voltage until the desired voltage is reached,
then long press and hold the M button until P02 flashes, then turn off and save the parameter settings.)
Throttle line 150cm, hole diameter 22mm.
24V 36V 48V 60V 72V Electric Bicycle Scooter Throttle LCD Display Shows
Speed, Mileage, and Battery Power
1. Phase speed or what is called Pointer meter, P04 can set the speed measurement mode,
where 0001 represents phase speed testing and 0002 represents Hall speed testing
2. Key lock or what is called electric lock or what is called electric door lock,
If the key is turned off and the LCD side is not turned off,
it indicates that the key lock wiring is reversed and must be changed before wiring.
3. Throttle
if connecting to the controller's throttle does not work, it means the throttle is not correctly connected
normally red to red, green to green, black to black should be connected,
but different controllers, throttles have different colors, the buyer must troubleshoot themselves
how to connect this throttle?
1. Phase voltage speed is connected to the controller's Pointer meter or phase voltage speed
2. Key lock is connected to the controller's key lock or what is called electric lock, electric door lock
3. Throttle is connected to the controller's throttle wires, needs color to color connection
if the throttle interface does not match the controller's interface, you must cut off the interface to connect. The buyer needs to do this themselves.
if the wire interface does not match the controller's interface, you must cut off the interface to connect. The buyer needs to do this themselves.
Guidelines for setting LCD instrument parameters:
Press and hold the M button to power on and enter the parameter setting mode:
\"Short press the M button to quickly switch to the upper row of P characters,
first showing P01 in descending order; * Long press the M button for more than 3 seconds,
the lower row of numbers flashes, and then short press the M button to change the parameters,
Hold for 5 seconds to save the current parameters.
Code:
P01 can be set to 24V, 36V, 48V, 60V, 72V voltage, with a default value of 48V
P02 can be set from 10 to 150, with a default value of 100
P03 can be set to 90-130, with a default value of 100
P04 can set the speed measurement mode, where 0001 represents phase speed testing and 0002 represents Hall speed testing
P05 can set wheel diameters of 8,10,12,14,16,18,20,22,24,26,28,29, with a default value of 14 inches
P06 can set the number of magnetic steels from 1 to 99, with a default value of 30
P07 can set the battery voltage display coefficient to 95-105, with a default value of 100
P08 can be set with three gear functions: P08=0 without gear, P08=1 default to first gear, P08=2 default to second gear, and P08=3 default to third gear. Default is 0
P09 mileage reset: After entering the parameters, long press for 3 seconds, the mileage flashes, and short press 10 times
Switch between P10 kilometers and miles, with 0001 representing kilometers and 0002 representing miles