Make your oil change quick and easy with our 12V oil change pump/diesel pump. Avoid spills and unnecessary hassle and get the job done smoothly and efficiently. The crocodile clips allow you to easily connect the pump to the battery. The pump has a bracket so that it can be easily mounted where needed. Easily sucks up the oil through the dipstick hole on the engine. Specification: Rated voltage: DC 12V Rated power: 60W Max pressure: Max. 0.8 MPa Maximum flow: 5L/min Pump diameter: approx. 4.8 cm, length: approx. 14.5 cm Outlet pipe diameter: approx. 10 mm x 137 cm (Dia. * L) Inlet pipe diameter: approx. 8 mm, 6 mm, length: approx. 110 cm Cable length: approx. 68 cm Cutting length: approx. 8 cm Black color How to use: 1) Start by running the car engine for a while, when the oil temperature is about 50 degrees, start pumping oil. 2) Connect the pump to the power, run it for a while and check if the inlet and outlet are normal. 3) Then open the filler cap, remove the dipstick and push the hose to the bottom of the oil pan. If no oil comes out, or if it is pumped up very slowly or intermittently, it is usually due to loose hoses and hose parts. You must reinstall the hoses and fittings. 4) After pumping oil, remove the hose and run the pump for a while. Pump out the remaining oil inside the pump, clean it or pump water for a while until the pump head is clean. 5) If you have not used it for a long time, it may not suck. Just pour water into the pump and run the pump for a few minutes until the air is completely out. Package includes: 1 x Oil pump 1 x 10 mm outlet pipe 1 x 8 mm hose 1 x 6 mm hose Note: If you want to connect this pump to the mains, you need a power converter. Please allow 1-5 mm deviation due to manual measurement. Due to light and screen differences, the item's color may be slightly different from the pictures.